Instructions

45
Multiplication Coefficient
Reset Offset
It can be adjusted from to .
For details, refer to the section where output functions are
defined
It can be adjusted from to . Changes in this
parameter is evaluated when counting starts.
If it is multiplication is not performed. So number of pulses are
displayed without having any changes.
Program Password
It is used for accessing to the program parameters. It can be adjusted
from to .
If it is , there is no password protection while accessing to the
parameters.
When programming button is pressed, will appear on the
display.
If program password is not “0” while accessing to the program
parameters ;
1- If user does not enter the value correctly ; operation screen
will appear without entering to operator parameters.
2- When in top display and in bottom display,if user
presses ENTER button without entering password (for observing the
parameters):
User can see all parameters except Program Password but device does
not allow to do any changes with parameters.