Instructions

When count value reaches the SET Value, Output Position is changed.
If Output Pulse time is not 0, then Output Position is changed
at the end of the Pulse time. Counting continue over SET value.
Counting value becomes 0 and output position becomes old position. If
output pulse time ,then output position has not
change until Manual Reset happens.
When Manual Reset happens, count value becomes Reset Offset
value.
41
Counting direction : 0 --> P (Upcounting)
=
Automatic Reset-4
0
Set
Reset
Output
0
Set
Reset
Output
=
=
=
Reset Offset
Reset Offset
i
If output functions parameter is selected Automatic Reset (
, or , then must be different from zero
for realizing Automatic Reset.