Instructions

40
Counting direction : P --> 0 (Downcounting)
=
0
Set
Reset
Output
0
Set
Reset
Output
=
=
Reset Offset
Reset Offset
When count value reaches the 0 Value, Output Position is changed. If
Output Pulse time is not 0, then Output Position is changed
the old position at the end of the Pulse time. Count value starts counting
from SET value. But 0 value is observed in actual value display. Real
counting value is shown on Actual value screen at the end of the Output
pulse time. If ,then output position has not changed
until Manual Reset happens. Counting process has not continue over 0
value.
When Manual Reset happens, if , then count
value becomes SET value. If ,then count value
becomes Reset Offset value.
=
=
=
i
If output functions parameter is selected Automatic Reset (
, or , then must be different from zero
for realizing Automatic Reset.