Instructions

37
Counting direction : 0 --> P (Upcounting)
=
Automatic Reset-2
0
Set
Reset
Output
0
Set
Reset
Output
=
=
When count value reaches the Set Value, Output Position is changed. If
Output Pulse time is not 0, then Output Position is changed
the old position at the end of the Pulse time. Actual value is reset and
counting starts from 0 value at the end of the Output Pulse time.
If output pulse time then, output position has not
change until Manual Reset happens. Actual counting value stops at SET
value. Counting process is not continue over the SET value.
When Manual Reset happens, count value becomes Reset Offset
value.
i
Reset Offset
Reset Offset
If output functions parameter is selected Automatic Reset (
, or , then must be different from zero
for realizing Automatic Reset.
=