Instructions

36
Automatic Reset-1
Counting direction : 0 --> P (Upcounting)
=
0
Set
Reset
Output
Output
=
=
When count value reaches the Set Value, Output Position is changed.
Actual value is reset automatically. Counting starts upcounting from 0
value. If Output Pulse time is not 0, then Output Position is
changed at the end of the Pulse time. If Pulse time
then Output Position has not changed until Manuel Reset happens.
When Manual Reset happens, count value becomes Reset Offset
value.
=
Counting direction : P --> 0 (Downcounting)
=
0
Set
Reset
Output
Output
=
=
Reset Offset
Reset Offset
When count value reaches the 0 Value, Output Position is changed.
Actual value is reset automatically. Counting starts downcounting from
Set value. If Output Pulse time is not 0, then Output Position
is changed at the end of the Pulse time. If Pulse time
then Output Position has not changed until Manuel Reset happens.
When Manual Reset happens; if , then count
value becomes SETvalue, if , then count value
becomes Reset Offset value.
=
=
=
i
If output functions parameter is selected Automatic Reset (
, or , then must be different from zero
for realizing Automatic Reset.