Instructions

123
In“PýnP Conf”Menu;
=;=;=;
=;=
Adjust Þ
6 - If operator or technician password is different from “0” and user
accesses to the parameter by Set button without entering the operator
or technician password and wants to change a parameter, the warning
message is shown on the bottom display as shown on the left. Device
does not allow to do any changes without entering the password
correctly.
7 - If tuning operation can not be completed in 8 hours, AT led starts to
blink.Blinking can be canceled by pressing Enter button.
8 - If user does not do anything for 120
seconds while device is on Operator or
Technician menus, device turns to operation
screen.
9 - When Ramp / Soak operation finishes ;
Ifanaloginputvalueisgreaterthanmaximumvalueofoperating
scale,topdisplaystartstoblink.
5-Iftopdisplayblinks:Ifanaloginputvalueisgreaterthan
maximumvalueofoperatingscale,topdisplaystartstoblink.
If parameter is , screen on the left is shown
(Please refer to Section 8.1.3 for bdsp parameter)
Please refer to Section 8.2.1 for detailed information about this
parameter.
Please refer to Section 8.1.2 for detailed information about this
parameter.
i
i
°C
°F
V
Remote
SV
AT
AUTO
MAN
RAMP
O1
O2
O3
SET
°C
°F
V
Remote
SV
AT
AUTO
MAN
RAMP
O1
O2
O3
SET
°C
°F
V
Remote
SV
AT
AUTO
MAN
RAMP
O1
O2
O3
SET
°C
°F
V
Remote
SV
AT
AUTO
MAN
RAMP
O1
O2
O3
SET
°C
°F
V
Remote
SV
AT
AUTO
MAN
RAMP
O1
O2
O3
SET
°C
°F
V
Remote
SV
AT
AUTO
MAN
RAMP
O1
O2
O3
SET