Instructions

In “PýnP Conf” Menu if;
= ; = ; = ;
= ; = are defined
Adjust Þ
7. Failure Messages in ESM-9930 Process Controllers
64
i
Please refer to Section 6.2.3 for detailed information about this
parameter.
1 - Sensor failure in analogue inputs. Sensor connection is wrong or
there is no sensor connection.
If analogue input value is greater than maximum value of operating
scale value on the top display starts to blink.
3 - If value on top display blinks : If analogue input value is greater than
maximum value of operating scale top display starts to blink.
4 - If technician password is different from “0” and technician accesses
to the parameters by Set button without entering the technician
password and wants to change a parameter, device does not allow to
do any changes in parameters. If increment or decrement button is
pressed, a warning message will appear on the bottom display as
shown on the left.
In “PýnP Conf” Menu if;
= ; = ; = ;
= ; = are defined.
Adjust Þ
If analogue input value is less than minimum value of operating scale
Value on the top display starts to blink.
2 - If value on top display blinks : If analogue input value is less than
minimum value of operating scale value on the top display starts
to blink.
Please refer to Section 6.2.3 for detailed information about this
parameter.
i
SET
P
AT A/M
°C
°F
VV
A
AT
ASET2
ASET1
PSET
PO
AO1
AO2
M
SET
P
AT A/M
°C
°F
VV
A
AT
ASET2
ASET1
PSET
PO
AO1
AO2
M
SET
P
AT A/M
°C
°F
VV
A
AT
ASET2
ASET1
PSET
PO
AO1
AO2
M
SET
P
AT A/M
°C
°F
VV
A
AT
ASET2
ASET1
PSET
PO
AO1
AO2
M