Instructions

Page 5
Page 21
Page 12
Page 7
CONTENTS
1.PREFACE............................................................................................................................................
1.1 GENERAL SPECIFICATIONS
1.2 ORDERING INFORMATION
1.3 WARRANTY
1.4 MAINTENANCE
2.INSTALLATION....................................................................................................................................
2.1 GENERAL DESCRIPTION
2.2 FRONT VIEW AND DIMENSIONS OF ESM-9910 TEMPERATURE CONTROLLER WITH
ONE RELAY
2.3 FRONT VIEW AND DIMENSIONS OF ESM-9910 TEMPERATURE CONTROLLER WITH
TWO RELAYS
2.4 PANEL CUT-OUT
2.5 ENVIRONMENTAL RATINGS
2.6 PANEL MOUNTING
2.7 INSTALLATION FIXING CLAMP
2.8 REMOVING FROM THE PANEL
3.ELECTRICAL WIRINGS......................................................................................................................
3.1 TERMINAL LAYOUT AND CONNECTION INSTRUCTION
3.2 ELECTRICAL WIRING DIAGRAM
3.3 LABELS FOR ESM-9910 TEMPERATURE CONTROLLER WITH ONE RELAY
3.4 LABELS FOR ESM-9910 TEMPERATURE CONTROLLER WITH TWO RELAYS
3.5 SUPPLY VOLTAGE INPUT CONNECTION OF THE DEVICE
3.6 TEMPERATURE INPUT CONNECTION
3.6.1 TC (THERMOCOUPLE) CONNECTION
3.6.2 RTD CONNECTIONS
3.6.3 PTC AND NTC CONNECTIONS
3.7 GALVANIC ISOLATION TEST VALUES OF ESM-9910 TEMPERATURE CONTROLLER
3.8 OUTPUT-1 CONNECTIONS
3.8.1 OUTPUT-1 ( RELAY OUTPUT ) CONNECTION
3.8.2 OUTPUT-1 DRIVER OUTPUT CONNECTION
3.9 OUTPUT-2 CONNECTIONS
3.9.1 OUTPUT-2 ( RELAY OUTPUT ) CONNECTION
3.9.2 OUTPUT-2 DRIVER OUTPUT CONNECTION
4.FRONT PANEL DEFINITION AND ACCESSING TO THE MENUS....................................................
4.1 FRONT PANEL DEFINITION FOR ESM-9910 WITH ONE RELAY
4.2 FRONT PANEL DEFINITION FOR ESM-9910 WITH TWO RELAYS
4.3 OBSERVATION OF ESM-9910 TEMPERATURE CONTROLLER SOFTWARE REVISION
4.4 CHANGING AND SAVING SET VALUES
4.4.1 ESM-9910 WITH ONE RELAY
4.4.2 ESM-9910 WITH TWO RELAYS
4.5 ENTERING TO PROGRAMMING MODE, CHANGING AND SAVING PARAMETERS
4.5.1 ESM-9910 WITH ONE RELAY
4.5.2 ESM-9910 WITH TWO RELAYS
5.PARAMETERS.....................................................................................................................................
5.1 SET PARAMETERS
5.2 PROGRAM PARAMETERS
6.FAILURE MESSAGE IN ESM-9910 TEMPERATURE CONTROLLERS............................................
7.CONTROL ALGORITHM.....................................................................................................................
7.1 ON/OFF CONTROL
7.1.1 ON/OFF CONTROL IN ESM-XX10 TEMPERATURE CONTROLLERS
8.SPECIFICATIONS................................................................................................................................
9.OTHER INFORMATIONS....................................................................................................................
Page 43
Page 41
Page 45
Page 44
3
Page 46