Instructions

3.5 Supply Voltage Input Connection of the Device
c
c
c
Make sure that the power supply voltage is the same indicated on the
instrument.
Switch on the power supply only after that all the electrical connections have
been completed.
Supply voltage range must be determined in order. While installing the unit,
supply voltage range must be controlled and appropriate supply voltage must
be applied to the unit. Controlling prevents damages in unit and system and
possible accidents as a result of incorrect supply voltage.
There is no power supply switch on the device. So a power supply switch must
be added to the supply voltage input. In accordance with the safety regulations,
the power supply switch shall bring the identification of the relevant
instrument.Power supply switch shall be easily accessible by the user.
Power switch must be two poled for seperating phase and neutral. On/Off
condition of power switch is very important in electrical connection. On/Off
condition of power switch must be signed for preventing the wrong connection.
If an external fuse is used, it must be on phase connection in Vsupply input.
If an external fuse is used, it must be on (+) line connection in Zsupply input.
The instrument is protected with an internal fuse (Please refer to Note-1 for
information). In case of failure it is suggested to return the instrument to the
manufacturer for repair.
16
Connection of Supply Voltage Input
230 V V ( ± %15 ) 50/60 Hz
115 V V ( ± %15 ) 50/60 Hz
NL
a
Y
c
Supply Voltage
24 V V ( ± %15 ) 50/60 Hz
External
Fuse
(1 A T)
10 11
Note-1
Note-1 : There is an internal 33R W fusible flameproof resistor in
There is an internal 4R7 W fusible flameproof resistor in
100-240 V V 50/60Hz
24VV 50/60Hz and 24VW 50/60Hz
Note-2 : “L” is (+),“N” is (-) for 24V Z Supply voltage
Note-3 : External fuse is recommended.
Note-3
24 V W ( - %15, + %10 ) 50/60 Hz
Note-2
Power
Supply
Switch