Instructions

8.1.3FunctionSelectionforTopandBottomDisplay
It defines the function of the top display. This parameter determines
which value is shown in top display.
It defines the function of the bottom display. This parameter determines
which value is shown in bottom display.
Process value (PV) is shown in top display.
Process set value (SV) is shown in bottom display.
If one of the analogue input modules is plugged in Module-1
or Module-2 socket, measured value from this module input
is shown in top display.
Status of the Ramp/Soak function is shown in bottom
display.
Result of subtraction of process set value from process
value .(SV-PV) is shown in top display
%Output value that is applied to process control output is
shown in bottom display.
If one of the analogue input modules is plugged in Module-1
or Module-2 socket, measured value from this module input
is shown in top display.
In ‘Run List’ menu Section 8.1.2, if operation form is , then parameter
is considered. If operation form is , %output value is shown in bottom display
whatever parameter is.
EMI-710
EMI-730
EMI-740
EMI-750
EMI-710
EMI-730
EMI-740
EMI-750
EMI-720
If CT input module (EMI-720) is plugged in Module-1 or
Module-2 socket, measured value from this module input is
shown in bottom display.
V
i
74