Instructions

PSET
°C
°F
VV
PO
AO1
AO2
A
AT ASET1 ASET2
M
SET
P
AT A/M
PSET
°C
°F
VV
PO
AO1
AO2
A
AT ASET1 ASET2
M
SET
P
AT A/M
PSET
°C
°F
VV
PO
AO1
AO2
A
AT ASET1 ASET2
M
SET
P
AT A/M
°C
°F
VV
PO
AO1
AO2
A
AT PSET ASET1 ASET2
M
SET
P
AT A/M
PSET
°C
°F
VV
PO
AO1
AO2
A
AT ASET1 ASET2
M
SET
P
AT A/M
PSET
°C
°F
VV
PO
AO1
AO2
A
AT ASET1 ASET2
M
SET
P
AT A/M
When Set button is pressed, Technician
Password Entering Screen is shown
Technician
Menu
Entering
Screen
38
Example-4 : To change ZVoltage / Current Input Calibration Type Selection parameter
In “PýnP Conf” menu
Parameter is in “PýnP ConF” menu. For accessing to this parameter, technician must
access to “PýnP ConF” menu firstly. In this example, changing input type of a device from
thermocouple to ZVoltage / Current and dual point calibration selection is shown.
Operation
Screen
When “P” button is pressed,
Technician Menu Entering
screen is shown.
If password is
not 0, Technician
Password
Entering Screen
is shown.
When screen is shown,
technician parameters can be seen
by pressing SET button without
entering password. But parameters
can not be changed. Please refer to
Section 6.2.9 ( Technician
Password)
Technician can access to the
following menu by pressing
menu changing next button
Run List Menu
Selection of operation form
DiSP List Menu
It defines which parameter will
be shown on top and bottom
display
Technician can access to the
following menu by pressing
menu changing next button
Technician Password
Press Set button to
confirm the password
Technician can access to the
former menu by pressing
menu changing back button.
Enter password with
increment and
decrement buttons