User manual

In “PınP Conf” Menu ;
=; =;=;
=; =
Adjust Þ
123
6 - If operator or technician password is different from “0” and user
accesses to the parameter by Set button without entering the operator
or technician password and wants to change a parameter, the warning
message is shown on the bottom display as shown on the left. Device
does not allow to do any changes without entering the password
correctly.
7 - If tuning operation can not be completed in 8 hours, AT led starts to
blink.Blinking can be canceled by pressing Enter button.
8 - If user does not do anything for 120 seconds
while device is on operator or technician menus,
device turns to operation screen.
9 - When Ramp / Soak operation finishes ;
If analogue input value is greater than maximum value of operating
scale , top display starts to blink.
5 - If top display blinks : If analogue input value is greater than
maximum value of operating scale , top display starts to blink.
If parameter is , screen on the left is shown
(Please refer to Section 8.1.3 for bdsp parameter)
Please refer to Section 8.2.1 for detailed information about this
parameter.
Please refer to Section 8.1.2 for detailed information about this
parameter.
i
i
°C
°F
V
O1
O2
O3
SV
REMOTE RAMP MAN AUTO
AT
SET
°C
°F
V
O1
O2
O3
SV
REMOTE RAMP MAN AUTO
AT
SET
°C
°F
V
O1
O2
O3
SV
REMOTE RAMP MAN AUTO
AT
SET
°C
°F
V
O1
O2
O3
SV
REMOTE RAMP MAN AUTO
AT
SET
°C
°F
V
O1
O2
O3
SV
REMOTE RAMP MAN AUTO
AT
SET
°C
°F
V
O1
O2
O3
SV
REMOTE RAMP MAN AUTO
AT
SET