Instructions

33
PSET
°C
°F
VV
PO
AO1
AO2
A
AT ASET1 ASET2
M
SET
P
AT A/M
°C
°F
VV
PO
AO1
AO2
A
AT PSET ASET1 ASET2
M
SET
P
AT A/M
°C
°F
VV
PO
AO1
AO2
A
AT PSET ASET1 ASET2
M
SET
P
AT A/M
°C
°F
VV
PO
AO1
AO2
A
AT PSET ASET1 ASET2
M
SET
P
AT A/M
i
Example-2 : Changing operation form from “Auto” to “Manual” and adjustment of % output.
If operation form is Auto (Close-Loop Control) and there is an output with PID or ON/OFF
control form, device controls the process outputs by calculating the % output values
automaticaly.
If operation form is Manual (Open-Loop Control) and there is an output with PID control form,
then % output value can be adjusted with increment and decrement buttons.
If operation form is Manual (Open-Loop Control), and there is an output with ON/OFF control
form, then %output value can be adjusted , or with decrement and
increment buttons.
If operation form is Manual, % output value is shown on bottom display whatever
parameter is.
Operation Screen
While it operates in automatic
mode, if auto/manual changing
button is pressed, it starts to
operate in manual mode
Operation Screen
It operates in Manual Mode
Press SET button
Process Set Screen
Press SET button
Operation Screen
It operates in Auto
Mode
If auto/manual changing
button is pressed, it starts
to operate in Auto Mode
PSET Led flashes
%Output value is shown on
bottom display
Auto/Manual Operation Form can be adjusted Auto or Manual with A/M button
from front panel. For using this button, Auto/Manual Operation Type
Selection Parameter must be .
For details on this parameter, refer to Section 6.2.8 General Parameters.