Instructions

15
Device Type
Housing & Mounting
Protection Class
Weight
Environmental Ratings
Storage / Operating Temperature
Storage / Operating Humidity
Installation
Overvoltage Category
Pollution Degree
Operating Conditions
Supply Voltage and Power
Temperature Sensor Input
NTC input type
PTC input type
Thermocouple input type
Thermoresistance input type
Accuracy
Cold Junction Compensation
Sensor Break Protection
Sampling Cycle
Control Form
Relay Outputs
Optional SSR Drive Output
Display
LED
Internal Buzzer
: Heating Controller
: 76mm x 34.5mm x 71mm plastic housing for panel
Mounting. Panel cut-out is 71x29mm.
: Ip65 at front, Ip20 at rear.
: Approximately 0.20 Kg.
: Standard, indoor at an altitude of less than 2000 meters
with none condensing humidity.
: -40 C to +80 C / -30 C to +80 C
: 90 % max. (None condensing)
: Fixed installation
: II.
: II, office or workplace, none conductive pollution
: Continuous
:
: 115
: 24
: 24
:10 - 30
: NTC, PTC, TC, RTD
: NTC (10 k @25 °C )
: PTC (1000 @25 °C )
: J, K (IEC584.1) (ITS 90)
: PT-100, PT-1000 (IEC751) (ITS 90)
: ± 1 % of full scale for thermoresistance
: Automatically ± 0.1°C / ± 1°C
: Upscale
: 3 samples per second
: ON / OFF
: A@250 V for Resistive load (Compressor output)
(Electrical life : 100.000 switching at full load)
: Maximum 20mA, Maximum 17V
: 14 mm Red 4 digits LED Display
: S (Green), P (Green), C (Yellow), F(Yellow),
Compressor Output (Red), Heating Output (Red)
: 83dB
: ,
oooo
oo
W
W
³
16(8) V
Approvals
230V ( %15) 50/60Hz - 1.5VA
V ( %15) 50/60Hz - 1.5VA
V ( %15) 50/60Hz - 1.5VA
V ( %15) 50/60Hz - 1.5VA
V 1.5WZ
Z
V
V
V
W
±
±
±
±
8. Specifications
7.Cooking Time (Timer) ON/OFF Operation
ü
3 sec.
In main operation screen, If cooking button is pressed for
3 seconds, then cooking time (Timer) is started and
cooking time active led becomes active. While cooking
time (Timer) continues if cooking button is pressed for 3
seconds, cooking time (Timer) is finished and cooking
time active led lights off.
If button protection parameter = 4 cooking time
(Timer)ON/OFF operation is performed when
button is pressed.
7.1 Cooking Time (Timer) ON/OFF Operation with Cooking Time Start/Stop Input
When K switch that is connected to the cooking time
start/stop input, getting closed condition, cooking time
(Timer) is started and cooking time active led becomes
active. While cooking time (Timer) continues if K switch
getting open condition, cooking time (Timer) is finished
and cooking time active led lights off.
DIGITAL INPUT
K
6
7
ENGLISH