User manual

4.8 Entering to the Programming Mode, Changing and Saving Parameters
Operation Screen
Hysteresis Parameter
SET
°C
SV
PR
If no operation is performed in programming mode for 20 seconds, device turns to
main operation screen automatically.
i
Programming Screen
Change the value with
increment and decrement
buttons.
Hysteresis
Press increment button for accessing to the
parameter value. Press Set button for
accessing to the next parameter.
SET
°C
SV
PR
SET
°C
SV
PR
Hysteresis
Press Set button for saving
the parameter.
Programming Screen
Hysteresis Parameter
Press Set button for accessing
to the next parameter.
SET
°C
SV
PR
SET
°C
SV
PR
Password Entering Screen
SET
°C
SV
PR
Programming Section
Entering Screen
SET
°C
SV
PR
Press increment
button for accessing
to the password
Password Entering Screen
SET
°C
SV
PR
Enter Programming Section
Accessing Password with
increment and decrement buttons.
Note-2: Parameters can be observed by pressing SET/OK button in password entering
screen without entering the programming section entering password. But parameters can
not be changed.
Press SET/OK button for
accessing to the parameters.
27
When SET button is pressed
for 5 seconds, “PR” led starts
to blink. If programming
section entering password is
different from 0, programming
section entering screen
is observed.
Note-1: If programming
section accessing
password is 0,
hysteresis screen
is observed instead of
programming screen
accessing password