Instructions

MODBUS ADDRESS:30001 Temperature Value
MODBUS ADDRESS:30002 Led Status : 0.bit C Led,6.bit OutputLed, 7.bit Alarm Led,
13.bit Program Led, 14.bit Set Led
MODBUS ADDRESS:30003 Device Status : 0.bit Alarm Status
1.bit Buzzer Status 2.bit Sensor Break Status
MODBUS ADDRESS:30004 Output Status 0.Bit Output
MODBUS ADDRESS:30005 Device Type and Device Version
o
A
6.3 ModbusAdresses of Device Status Parameters (Read Input Register)
11
Buzzer is active during this time
When this parameter is 1, if decrement button is pressed, is observed. In this
condition buzzer is active till buzzer silence button is pressed.
( Default = ) MODBUS ADDRESS:40019
If buzzer function selection parameter value =0, this parameter can not be
observed. Buzzer stays active during this time. It can be adjusted from 1 to 99 minutes
Programming Section Accessing Password 23
.
( Default = 0 ) MODBUS ADDRESS: 400
It is used for accessing to the programming section. It can be adjusted from 0 to 9999. If it is
selected 0, password will not be asked
PROKEY communication selected.
Communication Mode Selection Parameter 21( Default = 0 ) MODBUS ADDRESS: 400
RS-485 communication selected.
Slave ID Parameter 22( Default = 1 ) MODBUS ADDRESS=400
Device communication address parameter (1 to 247).
Temperature Alarm DelayAfter Power On Parameter
When power is first applied to the device, this time delay must be expired for activation of
temperature alarm. It can be adjusted from 0 to 99 minutes.
( Default = 0 )
MODBUSADDRESS:40017
Buzer Fonksiyon Seçimi Parametresi ( Default = 1 ) MODBUSADDRESS:40018
Buzzer is inactive.
Buzzer is active at the end of the cooking time.
Buzzer is active if an alarm occurs.
Buzzer is active during sensor failures.
Buzzer is active at the end of the cooking time, alarm or sensor failures.
Button Protection Parameter 20( Default = 0 ) MODBUSADDRESS: 400
There is no protection
Cooking time(Timer) can not be changed. Cooking ON/OFF operation is not
performed.
SET value can not be changed.
Cooking time (Timer) and set value can not be changed. Cooking ON/OFF
operation is not performed.
Cooking time (Timer) and set value can not be changed. Cooking ON/OFF
operation is performed when button is pressed.
ENGLISH