Technical data

7 | ENGLISH
5.1 Resetting the dimmer to the factory settings (Reset)
Under certain circumstances, it may be necessary to reset the dimmer to factory
settings and to reconfigure:
1. Press the dimmer's switch button three times within approx. 1.5 seconds (with an
insulated tool such as an insulated phase tester; Fig.1E). The LED (Fig.1F) in the
dimmer blinks.
2. Then press and hold the switch button for approx. five seconds until the LED
goes out. The dimmer has been reset to its factory settings.
Caution! When you reset to the factory settings, all the settings and connections for
this device are deleted. The radio system may no longer work and will need to be
reconfigured.
6.0 Z-wave Commands
Inclusion:
Have your Z-wave Controller entered inclusion mode, press the On/off button of the
mini switch three times.
Exclusion:
Have your Z-wave Controller entered exclusion mode, press the On/off button of the
mini switch three times. Once the node has been excluded, the LED will go into an
interval of two seconds on and two seconds off.
Reset:
Press the On/Off button three times to enter inclusion mode. Within one second, press
On/Off button again until LED is off. The home ID and node ID will be cleared and
reset to factory default.
7.0 Frequently Asked Questions
The latest frequently asked questions for your product can be found on the support
page of your product. Eminent will update these pages frequently to assure you have
the most recent information. Visit www.e-domotica.com/support/faqs for more
information about your product.
8.0 Service and support
This users manual has been carefully written by Eminent’s technical experts. If you
have problems installing or using the product, please fill out the support form at the
website
www.e-domotica.com/support/customer-service
You can also contact us by phone. Below you will find a list with phone numbers for
each supported country.