Manualshelf

Technical data

ManualsBrandsEminent ManualsDimmersEM6610
123456789
5 | ENGLISH
The fixing brackets or fixing screws of the blanking cover may also not press against
the housing; if necessary, change the mounting position of the dimmer accordingly.
Risk of fatal injury from electrical current.
The outputs may carry an electrical voltage even when the dimmer is switched off.
Always disconnect the fuse in the incoming circuit from the supply before working on
connected loads.
1. Disconnect the circuit from the mains.
2. Connect the dimmer as shown (Fig. 1):
a. Neutral conductor at terminal "N" (A).
b. Phase at terminal "L" (B).
c. Luminaire at terminal "~" (C).
d. Extension push-button (optional) at terminal "1" (D).
3. Place the antenna as far as possible from metal parts (connecting cables,
retaining rings, etc.) to avoid interruptions to the Z-wave signal.
Metal surfaces in the immediate vicinity of the dimmer can affect reception. Therefore,
do not install the dimmer in a flush-mounted box made of metal.
3.0 How to put the dimmer into operation
After installation:
1. Switch on the mains voltage.
2. The connected luminaires flicker for around ten seconds and then switch off
again. The dimmer has detected the load and is ready for operation.
Note: The lights will flicker in this way (load detection) after every interruption in the
mains voltage.
3.1 Add the switch to an e-Domotica e-Centre
1. Make sure your computer is completely started.
2. Open your computer’s web browser.
3. Enter “http://ecentre” in the address bar of your web browser and press the
‘Enter’ key on your keyboard.
4. The webpage of the e-Centre will be shown. If the Wizard is started, click ‘Exit
Wizard’ to go to the ‘e-Domotica Products’ page.
5. Click the ‘Include’ button. The e-Centre will start to search for new e-Domotica
devices.
6. Press the button on the dimmer three times within 1,5 seconds.
7. A message will appear: ‘Product found’.
If the device is not found, press the ‘Exclude’ button in the e-Centre’s webpage and
then click the button on your switch. After this procedure you can add the new device
correctly.