Install guide

62 | ENGLISH
5.3.3 Advanced
In some special situation, your network environment only provides PPPoE connection
(ADSL service), there is no NAT/router available. You will then need to set the PPPoE
settings in the “Advanced Network” page. Only the PPPoE username and password
are needed to let PPPoE work. After the “Save & Apply” button is clicked, the PPPoE
function will work immediately. You can check the “Registration status” in the
“Information” page to see if the EM6250 is registered using the PPPoE connection.
Please notice that the DHCP or static IP settings in the “Network” page can work
together with the PPPoE connection. Only the PPPoE has higher priority, so, if the
PPPoE is working, the EM6250 will use PPPoE to connect to the Internet.
The default setting is “Disable PPPoE”.