Install guide

ENGLISH

5.3.2 Wi-Fi security

You can use the wireless connection to connect the EM6250 to the network. If your

network environment has a 802.11 b/g/n router or AP running, you can click the

“Enable Wi-Fi function” button to enable the wireless connection.

In order to use the wireless network, you need to fill in the following fields:

1. SSID – this is the ID (name) of the wireless router or AP of your wireless network

environment, this must be set correctly.

2. Security mode – this is the security mode used in your wireless router or AP. You

need to choose one of the three modes – None, WEP or WPA-PSK.

WEP : Wireless Encryption Protocol.

WPA/WPA2 : Wi-Fi Protected Access.

PSK : Pre-Shared Key.

TKIP : Temporal Key Integrity Protocol.

AES : Advanced Encryption Standard.

3. WEP encryption – when the WEP mode is chosen, you need to choose between

64-bit(5 char), 64-bit(10 hex), 128-bit(13 char) and 128-bit(26 hex) encryption

mode, and then fill out the WEP key correctly.

4. WPA encryption - when the WPA-PSK mode is chosen, you need to choose

between TKIP and AES encryption mode, and then fill out the WPA-PSK key

correctly. WPA2-PSK is also supported. But WPA Enterprise or WPA2 Enterprise

is not supported.

All the fields in this page must be filled out correctly, with the same settings as the

wireless router or AP are using.