Install guide

ENGLISH

capable Wi-Fi router.

• PIR sensor – for the detection of movement.

• Light detector – for light intensity detection to be able to switch automatically

between Day and Night

• IR LED – for the Infra-Red lighting of the night mode usage.

• Infrared Thermometer – detects the environment temperature

• Microphone – for receiving the audio/voice. Effective distance is about 5 meters.

• Internal Speaker – for two way audio and speaker alarm usage.

• External Speaker jack – connect to an external speaker for two way audio and

speaker alarm usage.

• Micro-SD card slot – for inserting the Micro-SD Card. (support up to 32G bytes)

Major components of the front and side panel

The components on the back and bottom panel of the EM6270 are the bracket screw

jack, power jack, Ethernet jack and reset button:

• Bracket screw jack – this is the position to screw in a bracket.

• Power jack – this is the place to plug in the power adapter. The power needed for

this EM6270 is 12V/1.0A or 5V/1A, please make sure you are using the correct

power adapter.

• Ethernet jack – this is the place to plug in the RJ45 Ethernet cable. When the

Ethernet link is ok, the Ethernet indication LED on the front side will be blue light.

• Reset button – this is the button to reset the EM6270 to default factory settings.

You need to use a small stick like pencil or tooth stick to press the reset button for

more than 3 seconds to enable the reset function. Usually when you forgot the

administrator account, you will probably need to do this reset action to reset to the

default factory settings. Please refer to section 5.6.6 for more details.

• Wall Mount – This is used to mount the device to the wall or ceiling.