Install guide

ENGLISH

1.0 Introduction

Congratulations with the purchase of this high-quality Eminent product! This product

has undergone extensive testing by Eminent’s technical experts. Should you

experience any problems with this product, you are covered by a five-year Eminent

warranty. Please keep this manual and the receipt in a safe place.

1.1 Packaging contents

The following parts need to be present in the packing:

• EM6270 Easy pro view HD Pan/Tilt IP camera

• Power supply

• Power extension cable 1.5m

• Quick install guide

• Network cable

• Screws and plugs

• CD-ROM with software and wizard

• ID/Password card

1.2 Requirements to access the camera.

It is very easy to access the video images of the EM6270 on your smartphone, tablet

or PC. You only need the ID and password that is written on your ID/Password card

and download the application for your device. You do not need to remember or setup

the configuration of your modem/router to be able to access the camera.

1.3 Major hardware components.

The components on the front and side panel of the EM6270 are:

• Lens – the lens is inside the camera body and the focus of the lens is fixed, you

do not need to spend time to adjust the focus, the effective focus range is from

30cm to infinity. There are two lens for day and night usage separately.

• Status indication LED (red) – this LED is to indicate the Internet connection status.

When the Internet connection is connected, the LED will be constant red light. If

there is any Internet connection problem, the LED will be blinking red light.

• Ethernet indication LED (blue) – this LED is to indicate if the Ethernet link is ok

and packet traffic is sending/receiving. When the Ethernet cable is connected, the

LED is on. When there is packet sending/receiving, the LED is blinking blue light.

• SD card indication LED(yellow) – this LED is to indicate the status of the Micro-SD

card recording, it will be on when the Micro-SD card is inserted and will blink

during recording.

• WPS button – this is to automatically synchronize the Wi-Fi settings with a WPS