Specifications

Emhart Teknologies - 50 Shelton Technology Center, Shelton CT 06484 - Tel. [phone] - Fax [phone] Page 9
Cleaning the MCS Filter
For optimal performance, the MCS filter should be cleaned at regular intervals per the “Preventative
Maintenance Schedule”.
Note: Turn off MCS unit AND UNPLUG AIR SUPPLY while servicing MCS to avoid INJURY.
1. CLEAN THE MANDREL COLLECTION UNIT:
• Remove and empty the Collector Bottle (22)
by unscrewing counterclockwise.
• Remove the Filter Cover Assembly (43) by
taking hold of the center stem and pulling
the assembly out.
• Remove the Filter (24).
• Remove debris from the back of the MCS
taking care not to let debris fall into the
piston shaft area.
2. RE-ASSEMBLE THE MANDREL
COLLECTION UNIT:
• Place the Filter (24) back into the MCS unit
ensuring that the oval slot in the filter
exposes the two holes in the back of the
MCS.
• Insert the Filter Cover Assembly (43) into
the recess in the back of the unit, O-rings
first.
• Screw on the Collector Bottle (22) hand-tight
so that the O-ring (33) seal squeezes tightly
against the back of the MCS unit.
Filter Cover Assembly (43)
Filter (24)
Low-flow adjustment screw
(use small screwdriver to adjust)
Switch Ring (21)
Vacuum hole
Collector Bottle (22)
w/ O-Ring (33)