Specifications

Emhart Teknologies - 50 Shelton Technology Center, Shelton CT 06484 - Tel. [phone] - Fax [phone] Page 17
LUBRIPLATE
®
130-AA
Manufactured by:
Fiske Brothers Refining Co.
Phone: [phone]
First Aid:
SKIN:
Remove any contaminated clothing
and wash with soap and warm
water. If injected by high pressure
under skin, regardless of the
appearance of its size, contact a
physician IMMEDIATELY. Delay
may cause loss of affected part of
body.
INGESTION:
Call a physician immediately. Do
not induce vomiting.
EYES:
Flush with clear water for 15
minutes or until irritation subsides.
If irritation persists, consult a
physician.
Fire:
FLASH POINT: COC- 400°F
Cool exposed containers with water.
Use foam, dry chemical, carbon
dioxide or water spray.
Environment:
WASTE DISPOSAL:
Assure conformity with applicable
disposal regulations. Dispose of
absorbed material at an approved
waste disposal facility or site.
SPILLAGE:
Scrape up grease, wash remainder
with suitable petroleum solvent or
add absorbent.
Handling/ Storage:
Keep containers closed when not in
use. Do not handle or store near
heat, sparks, flame or strong
oxidants.
JAW LUBE (P/N: PRG510-130)
Distributed By:
Emhart Teknologies
Phone: [phone]
First Aid:
SKIN:
Wash with soap and water until no
odor remains. If redness or swelling
develops, obtain medical
assistance. Wash cloths before
reuse.
INGESTION:
Do not induce vomiting! Do not give
liquids! Obtain emergency medical
attention. Small amounts that
accidentally enter mouth should be
rinsed out until taste of it is gone.
EYES:
Flush with water.
Fire:
FLASH POINT: Greater than 200°F
Can be made to burn. Use water
spray, regular foam, dry chemical or
carbon dioxide.
Environment:
WASTE DISPOSAL:
Do not flush to drain or storm sewer.
Contract authorized disposal
service.
SPILLAGE:
Contain Spill. Absorb onto inert
material. Shovel, sweep or vacuum
spill.
Handling/ Storage:
NFPA Class IIIB Storage. Avoid
prolonged breathing of mist or
vapor. Avoid prolonged or repeated
contact with skin. Avoid contact
with eyes. Wash thoroughly after
handling.
MOBIL DTE 26 (P/N: PRG540-130)
Distributed By:
Emhart Teknologies
Phone: [phone]
Manufactured By:
ExxonMobil Corporation
Emergency Phone: [phone]
MSDS Fax on Demand:
[phone] MSDS # 602649-00
First Aid:
SKIN:
Remove contaminated clothing and
shoes and wipe excess from skin.
Flush skin with water, then wash
with soap and water. If irritation
occurs, get medical attention. Do
not reuse clothing until cleaned.
INGESTION:
Do not induce vomiting. In general,
no treatment is necessary unless
large quantities of product are
ingested. However, get medical
attention.
EYES:
Flush with water. If irritation occurs,
get medical attention.
Fire:
FLASH POINT: 390 °F/198.9 °C
Material will float and can be re-
ignited on the surface of water. Use
water fog, ‘alcohol foam’, dry
chemical or carbon dioxide (CO
2
) to
extinguish flames. Do not use a
direct stream of water.
Environment:
WASTE DISPOSAL:
SPILLAGE:
Soak up residue with an absorbent
such as clay, sand or other suitable
material. Place in a non-leaking
container and seal tightly for proper
disposal.
Handling:
Wash with soap and water before
eating, drinking, smoking, applying
cosmetics or using toilet. Properly
dispose of leather articles such as
shoes or belts that cannot be
decontaminated. Use in a well
ventilated area.
Storage:
Store in a cool, dry place with
adequate ventilation. Keep away
from open flames and high
temperatures.
Please refer to the actual MSDS for complete safety and handling
information. These can be obtained from the point of purchase.
Safety Data