Instruction manual

Safety Data
SEAL LUBE
(P/N: PSA075508P) JAW LUBE (P/N: PRG510-130) HYDRAULIC OIL (P/N: PRG540-130)
LUBRIPLATE
®
130-AA
Manufactured by:
Fiske Brothers Refining Co.
Phone: [phone]
Emergency: [phone]
ALVANIA
®
EP Grease 1
Prod Code: 71124
Manufactured by:
Shell Oil Products
Phone: [phone]
MSDS#: 57072E-5
First Aid:
SKIN:
Remove any contaminated clothing and
wash with soap and warm water. If
injected by high pressure under skin,
regardless of the appearance of its size,
contact a physician IMMEDIATELY.
Delay may cause loss of affected part
of body.
INGESTION:
Call a physician immediately. Do not
induce vomiting.
EYES:
Flush with clear water for 15 minutes or
until irritation subsides. If irritation
persists, consult a physician.
Fire:
FLASH POINT: COC- 400°F
Cool exposed containers with water.
Use foam, dry chemical, carbon dioxide
or water spray.
Environment:
WASTE DISPOSAL:
Assure conformity with applicable
disposal regulations. Dispose of
absorbed material at an approved
waste disposal facility or site.
SPILLAGE:
Scrape up grease, wash remainder with
suitable petroleum solvent or add
absorbent.
Handling/ Storage:
Keep containers closed when not in
use. Do not handle or store near heat,
sparks, flame or strong oxidants.
Lubriplate
®
is a registered trademark of Fiske
Brothers Refining Company.
SUNPAR 107
MOBIL DTE 26
Manufactured By:
Manufactured By:
Sunoco, Inc.
ExxonMobil Corporation
Emergency Phone: [phone]
Emergency Phone: [phone]
MSDS Fax on Demand:
First Aid:
[phone] MSDS # 602649-00
SKIN:
Wash with soap and water until no
Shell TELLUS 68
odor remains. If redness or
Manufactured By:
swelling develops, obtain medical
SOPUS Products
assistance. Wash cloths before
Health Information: [phone]
reuse.
MSDS Assistance:
[phone] MSDS # 402288L-0
INGESTION:
Do not induce vomiting! Do not
Distributed By:
give liquids! Obtain emergency
Emhart Teknologies
medical attention. Small amounts
Phone: [phone]
that accidentally enter mouth
should be rinsed out until taste of it
First Aid:
is gone.
SKIN:
Remove contaminated clothing and
EYES:
shoes and wipe excess from skin.
Flush with water.
Flush skin with water, then wash with
soap and water. If irritation occurs,
Fire:
get medical attention.
FLASH POINT: Greater than 200°F
INGESTION:
Can be made to burn. Use water
Do not induce vomiting. In general, no
spray, regular foam, dry chemical or
treatment is necessary unless large
carbon dioxide.
quantities of product are ingested.
However, get medical attention.
Environment:
WASTE DISPOSAL:
EYES:
Do not flush to drain or storm sewer.
Flush with water. If irritation occurs, get
Contract authorized disposal
medical attention.
service.
Fire:
SPILLAGE:
Contain Spill. Absorb onto inert
FLASH POINT: 390°F
/198.9°C
material. Shovel, sweep or
Material will float and can be re-ignited
vacuum spill.
on the surface of water. Use water fog,
‘alcohol foam’, dry chemical or carbon
Handling/ Storage:
dioxide (CO2) to extinguish flames. Do
NFPA Class IIIB Storage. Avoid
not use a direct stream of water.
prolonged breathing of mist or
vapor. Avoid prolonged or
Environment:
repeated contact with skin. Avoid
SPILLAGE:
contact with eyes. Wash thoroughly
Soak up residue with an absorbent such
after handling.
as clay, sand or other suitable material.
Place in a non-leaking container and
seal tightly for proper disposal.
Handling:
Wash with soap and water before
eating, drinking, smoking, applying
cosmetics or using toilet. Properly
dispose of leather articles such as
shoes or belts that cannot be
decontaminated. Use in a well
ventilated area.
Storage:
Store in a cool, dry place with adequate
Please refer to the actual MSDS for complete safety and handling
information. These can be obtained from the point of purchase.
ventilation. Keep away from open
flames and high temperatures.
Page 16 Emhart Teknologies - 50 Shelton Technology Center, Shelton CT 06484 - Tel. [phone] - Fax [phone]