Specifications

Page 12 Emhart Teknologies - 50 Shelton Technology Center, Shelton CT 06484 - Tel. [phone] - Fax [phone]
Tool Setup
Initial Setup
1. Check that the correct Nosepiece and Mandrel are fitted for the POP NUT™. See the Basic
Tool Operation section for proper tool adjustment.
2. Connect an air fitting to the Swivel Air Fitting of the tool. The Swivel Air Fitting is a 1/4 NPTF
thread.
3. Connect an Air Hose to the tool.
4. Connect an air filter, regulator and lubricator in the air line between the air supply and Air Hose
connecting to the tool, within 3m [6 ft ] of the tool.
5. Adjust the air pressure supply and oil drip volume of the lubricator
• Air Pressure: 0.5-0.6 MPa. (72.5-87 psi)
• Oil drip volume: 1-2 drops/ 20 nuts fastened
Figure 3: Tool Setup
Note: Refer to the instruction manual for the Lubricator used for the proper adjustment method and
lubrication oils to use relating to air motors.
WARNING!
Use an air hose with a rating of 1.0 MPa (145 psi / 10 bar) or greater maximum ordinary operating
pressure. Also make sure the hose material is suitable for the operating environment (i.e. oil proof, wear
and abrasion resistance etc.). For details, refer to your hose manufacturer's catalog.