Installation Guide

- 9V +
FROM PICKUP
VOLUME
OUTPUT
T
R
S
OUTPUT CABLE
NOTE:
REVERSED
CONNECTOR
BATTERY
BUSS
BATTERY
NEG (-)
RED
RED
RED
VMC
VARIABLE MID-RANGE FREQUENCY
VARIABLE MID-RANGE CUT
10KHz1KHz
20Hz
10 dB/div
VARIABLE MID-RANGE BOOST
10KHz
1KHz
20Hz
10 dB/div
The VMC Control is easily installed by using the connector cables supplied.
Diagram #1 shows the cables connected to the VMC Control. This 5-pin
layout is the same for all EMG Accessories, so they can be interchanged.
There are a variety of ways instruments can be wired. The examples shown
here are only a few. If your instrument has different wiring than shown here
go to our website: http://www.emgpickups.com for alternate diagrams.
Diagram #2 below shows the installation of a single Volume control along with
the VMC Control.
Mid Frequency Selection:
The lower control of the VMC allows you to choose the mid-range
frequency to effect either boost or cut. The upper control of the
VMC effects the amount of boost or cut of the chosen frequency
and has a center detent for flat frequency response, or no effect
from the VMC Control.
VMC Control Page 2
NOTE: REVERSED
INPUT CONNECTOR
OUTPUT TO JACK
INPUT
Installation Instructions:
EMG Model: VMC Control
RED TO 9V + BUSS
FREQUENCY SELECTION (LOWER CONTROL)
BOOST OR CUT (UPPER CONTROL)
Diagram #1
1.0KHz100Hz
20Hz
10 dB/div
10KHz1KHz
Diagram #2
Master Volume
VMC Control