Installation Guide

1.25
(31.8)
.820
(20.8)
1.00
(24.9)
.540
(13.7)
.940
(23.9)
.390
(9.9)
INPUT
GROUND
GROUND
OUTPUT
VOLTS +
FREQUENCY
BOOST OR CUT
0230-0220A
SPECIFICATIONS
Input Impedance (Ohms) 500K Ohm
Gain/Attenuation/ Mid Frequency Control +/-12db/(Adjustable)
Input Referred Noise -120dbV
Output Impedance (Ohms) 2K
Recommended Supply Voltage 18 Volts
Current @ 9V/18V (Microamps) 600/740
Battery Life (Hours) 750
Maximum Supply (Volts DC) 27 Volts
INSTALLATION INFORMATION
EMG MODEL: EMG-VMC CONTROL
Dimensions:
BTC (Bass/Treble)
Equalizer
Warranty
All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If
upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This
warranty covers only those pickups and accessories sold by authorized EMG Dealers. This warranty is not transferable.
© 2011 Copyright EMG INC. All Rights Reserved.
PO
BOX 4394
SANTA ROSA, CA
95402 USA
P [phone]
F [phone]
EMGPICKUPS.COM
INCLUDED:
1 VMC Control
1 Set Concentric Knobs
1 Battery Clip with Buss Connector
1 Stereo Output Jack (Battery Switching)
4 Interconnect Cables (2 Red, 2 White)
General Operation
The EMG-VMC is and active EQ Circuit for bass and guitar. Its effects are illustrated in the graphs on Page 2. Rotate the upper control clock-
wise for boost, counterclockwise for cut. Leave it in the center detent position for flat response. Rotate the frequency knob to sweep through
the mid-frequency band from 100 Hz to 1000 Hz. The VMC can be used in combination with the EMG-BT (Bass/Treble) controls as well as any
of the other EMG accessories. It uses EMG’s typical 5 pin connector for simple installation.