VS mn 2] K|PS HI INSTALLATION INFORMATION, DIRECT REPLACEMENT EMG Models MEG-S, E MG-SA, E MG-SV, E MG-SAV, EMG COMBINATION SYSTEMS Specifications Model: E MG-SA E MG-SAV Gold 3.75 Logo Color Resonant Frequency (Khz) RMS Quip Voltage Peak Output Voltage Output Noise {dbV} Output Impedance {Ohm) . Current @ 9Y {microscopic. Battery Life (Specifications shown are the entire 3 Pickup System} IMPORTANT INSTALLATION NOTES: 1) Only one battery is required per instrument.
installation procedure and diagram for EMG Systems: MEG-8, E MG-SA, E MG-3V and E MG-SAV and MEG-COMBINATION SYSTEMS. 1} Remove the strings. 2} Unscrew the output jack plate and unsold er the two wires from the output jack. 3} Unscrew and remove the pick guard from the body with the pickups, controls and selection switch intact. 4) Cut the bridge ground wire going to the vibrato cavity. It will not be reconnected. See: IMPORTANT NOTES (note 5) on page 1.
Diagrams for Combination Systems including the MEG-89 Refer to Diagrams: 34, 38 and 4 Diagram 3A Switch up: Humbler on, Switch down: Single coif on The pushily switch on the MEG-89 can be wired two different ways, Diagram 3A shows the push/pull switch wired with the Humbler ON in the PULL position and the Single-Colt ON in the PUSH position. This is standard factory wiring. In Diagram 3B the push/pull switch is wired with the Single-Coil ON in the PULL position and the Humbler ON in the PUSH position.
Installation Diagram for adding two accessory circuits, E MG-SPC, RPC, or EXG to an existing harness. Refer to Diagrams 1 and 6 Removing both Tone Controls: 1) Unscrew the output jack plate and unsold er the three wires from the output jack. 2) Remove the strings and unscrew the pick guard from the body with the pickups and controls intact, 3) Removing both Tone Controls. a) Unsold er and remove the white wires from lugs 5 and 6 at the selector switch.
