User Guide

1
2
3
4
5
6
7
8
VOLUME
B122rH
TONE
B124rH
VOLUME
B122rH
TONE
B124rH
BRIDGE PICKUP
NECK PICKUP
BATTERY
NEG (-)
MASTER
VOLUME
T
R
S
OUTPUT CABLE
RED
RED
RED
GROUND
BRIDGE P/U
NECK P/U
OUTPUT
- 9V +
MASTER
TONE
BRIDGE PICKUP
NECK PICKUP
BATTERY
NEG (-)
MASTER
VOLUME
T
R
S
OUTPUT CABLE
RED
RED
RED
GROUND
BRIDGE P/U
NECK P/U
OUTPUT
- 9V +
MASTER
TONE
The KFK System is shown below wired just like Kerry’s Guitar. Diagram #5 shows a
toggle switch, and diagram #6 shows a lever style switch. There are two volume
controls and two tone controls included with the KFK System so be sure to see
Page 4 showing two alternate installation diagrams.
Refer to Diagram #5
1) Install the Pickups and route the Pickup cables to the control cavity.
If the cables are too long, keep any excess under the pickup.
2) Plug both Pickup cables onto the Pickup Buss (BLACK Shroud) as shown,
Bridge Pickup to position 1. Neck Pickup to position 2.
3) Plug a coax cable from the Pickup Buss (position 3) to the Master Volume.
4) Plug a coax cable from the Master Volume to the Master Tone as shown.
5) Plug a coax cable from the Master Tone to the PA2, and note the reversed
connector on the PA2.
6) Strip the insulation from the switch wires and Insert them into the GREEN
Terminal Block and tighten the screws with a small screwdriver.
The BR Terminal is the Bridge Pickup, The NK Terminal is the Neck Pickup, the
output of the switch goes to the O terminal. Use the BLACK section of the
terminal block for any ground connections.
7) Plug the output cable from the PA2 to the output jack by pushing the connectors
onto the output jack terminals, WHITE wire to the (T) contact, BLACK wire to the
(S) contact
8) Plug the BLACK Battery Negative wire onto the RING (R) contact.
9) Plug the RED Wires of the pickups onto the V+ Supply Buss (RED Shroud)
along with the RED wire of the PA2 and the RED wire of the battery clip.
10) Put the battery in the insulating foam piece provided and place it securely in
the control cavity. We suggest that you plug in the instrument and test it before
closing the control cavity.
KFK INSTRUCTIONS Page 3
2 Pickups / Toggle Select Switch / Master Volume and Tone with a PA2
Diagram #5
2 Pickups
Toggle Style Select Switch
Master Volume & Master Tone
PA2
Diagram #6
2 Pickups
Toggle Style Select Switch
Master Volume & Master Tone
PA2
Diagram #4
Insert the plug onto the 3 pin header
of the pickup as shown above.
Note the orientation arrow.
NOTE:
REVERSED CONNECTOR
PA2
NOTE:
REVERSED CONNECTOR
PA2