User Guide

ManualsBrandsEMG ManualsElectric Guitar PartsEMG KFK Kerry King 81/85 Active Guitar Humbucker Pickup Set, Black

.390

(10)

(6)

(8)

.235

.310

INSTALLATION INFORMATION

EMG MODEL: EMG-KFK SET (EMG-81 / EMG-85 / EMG-PA2)

2 PICKUP CABLES 11”(28cm) 15” (38cm)

OUTPUT CABLE 6” (15cm)

5 CONNECT CABLES 5.5” (14cm)

BATTERY CABLE 7” (18cm)

B245

SUPPLY CABLE 5.5” (14cm)

2.75

1.50

3.09

3/48 MOUNTING HOLES

.900

.725

(69.8)

(38.1)

(22.8)

(18.4)

(78.5)

- 9V +

BATTERY

BUSS

PICKUP IN/ OUT

BATTERY BUSS

STEREO OUTPUT

JACK

2 VOLUME CONTROLS (25K)

2 TONE CONTROLS (25K)

ADJUSTMENT (2 PAIR)

SCREWS & SPRINGS

PA2

Warranty

All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If

upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This

warranty covers only those pickups and accessories sold by authorized EMG Dealers. This warranty is not transferable.

PO BOX 4394

SANTA ROSA, CA

95402 USA

P (707) 525-9941

F (707) 575-7046

EMGPICKUPS.COM

0230-0105rB

Note: Magnet Type: A (Alnico)

C/S (Ceramic/Steel)

Installation notes:

All EMG Pickups are compatible with each other. The connector system is an easy method of installation, avoiding the need to solder.

Older systems may need to be soldered, while the newer systems can be easily connected and modified. If you have an older EMG

Pickup you can install the new system along with it.

EMG accessories like the VLPF, EXG, SPC or RPC Controls can be added to any EMG Pickup System without the need for an extra battery.

SPECIFICATIONS: MODEL:

81 85 PA2

Logo Color Silver Gold Input Impedance(Ohms) 500K

Magnet Type * C/S A Noise -130dbV

Resonant Frequency (KHz) 1.63 1.87 Output Impedance (Ohms) 2K

Output Voltage (String) 3.00 3.10 Current @ 9 Volts (Microamps) 290

Output Voltage (Strum) 4.50 4.50 Battery Life (Hours) 1725

Output Noise (60 Hz) -100 -101 Maximum Supply (Volts DC) 27

Output Impedance (Kohm) 10 10

Current @9V (Microamps / system) 160

Battery Life (Hours / System) 1500

Maximum Supply (Volts DC) 27

Included with THE KFK SYSTEM:

Summary of content (4 pages)

PAGE 1
2.75 (69.8) 0230-0105rB 1.50 (38.1) PO BOX 4394 SANTA ROSA, CA 95402 USA 3.09 (78.5) 3/48 MOUNTING HOLES P (707) 525-9941 F (707) 575-7046 EMGPICKUPS.COM .725 (18.4) .900 (22.
PAGE 2
Installation Instructions: EMG Model: KFK Set (EMG-81 / 85 / PA2) General Notes: Every attempt has been made to make this a solderless installation. There are some instances where this is not possible; 1) If your instrument uses the long panel output jack and you had passive pickups you will need a new stereo output jack, the Switchcraft 152B is recommended. Soldering to the new jack will be required, see diagram #2 below. 2) if your instrument has a battery holder see diagram #3 below.
PAGE 3
2 Pickups / Toggle Select Switch / Master Volume and Tone with a PA2 The KFK System is shown below wired just like Kerry’s Guitar. Diagram #5 shows a toggle switch, and diagram #6 shows a lever style switch. There are two volume controls and two tone controls included with the KFK System so be sure to see Page 4 showing two alternate installation diagrams. 9) Plug the RED Wires of the pickups onto the V+ Supply Buss (RED Shroud) along with the RED wire of the PA2 and the RED wire of the battery clip.
PAGE 4
- 9V + BATTERY NEG (-) R GROUND S NECK P/U T OUTPUT CABLE RED B124rH OUTPUT RED BRIDGE P/U TONE RED Diagram #7 2 Pickups Toggle Style Switch Volume each Pickup (Volumes are independent) Master Tone and PA2 MASTER TONE NK VOLUME NECK PICKUP B122rH VOLUME BR VOLUME BRIDGE PICKUP B122rH VOLUME Refer to Diagram #7 Above: 1) Install the Pickups and route the pickup cables to the control cavity. If the cables are too long, wind up any excess and keep it under the pickup.