iF mm PICKUPS oro INSTALLATION INFORMATION Models SPC, RPC, EXG “ov 008s 06 FED (oir) © The SPC, RPC, and EXG are active EQ circuits. The EXG SPC is a mid-range boost. The RPC is a low cu thigh boost, The EXG is a low and high boast and is effectively a mid-range cut. The graphs to the right illustrate the effects of the controls. The thick line displays the effect with the control all the way up {clockwise}.
3 Pickups with a 5-Way Switch and 1 EQ Red {Vomits +) Black (Ground) PREPARATION 1) Unscrew the output jack plate and unsold er the three wires from the output jack Remove the strings. To] Ey White flout) 3) Unscrew and remove the pick guard from the body with the pickups. controls, and selection switch intact. Green (Output) Refer to Diagram #1 4) Unsold er and remove the white wire from lug 6 of the selector switch. 5) Cut and remove the jumper wire between lug tone 2 and lug 1 of tone 1.
Pickups, 5-Way Switch, 2 EQ PREPARATION 1) Unscrew the output jack plate and underside the three wires from the output jack, 2) Remove the strings. 3) Unscrew and remove the pick guard from the body with the pickups, controls, and selection switch intact Refer to Diagram #1 4) Unsold er the two white wires on lugs 5 and 6 of the selector switch. 5} Unsounder the thick silver ground buss wire from the vol ume control casing. 8) Remove the two tone controls from the pick guard.
