User Guide

BANJO PICKUP / VOL Page 3
Installation Instructions:
EMG Model: BANJO PICKUP
TO VOLUME
JACK
TO PICKUP
4) Battery Holder and Battery Installation
Install the Battery Holder as shown on the rods and
install two CR2032 batteries. Be sure the positive side of
both batteries are facing the Battery Holder spring terminal.
5) Output Jack/ Volume Installation
Install the Output Jack assembly as shown below. Slide the threaded
strip behind the lugs and tighten using the four screws provided.
7) Wire it up
Route the cables as shown by paying attention to the
color codes marked on the pickup and battery
holder PC Boards.
Positive of both batteries facing out
6) Output Cable
Plug in the output cable as shown below. Be sure the wire colors
match the legend on the box. R(Red), B(Braid), W(White).