Installation

Section 3) V+ Supply Buss for EMG Accessories
Three pins are available to supply +9V for up to 3 EMG Accessory circuits
such as the VLPF, SPC, EXG, PA2, or RPC. Plug the RED wire(s) of those
accesories onto the V+ Buss as shown.
Output of the
selection switch
Diagram #10
Section 4) Output / Ring and Battery Supply
Diagrams #10 and Diagram #11
The 5-pin Header near the top of the switch provides:
Output of the switch:
The OUT pins marked GND and SIG go to the master volume control as shown in Diagram #10
Ring to the Output Jack (Battery Negative):
The Ring pin goes directly to the Ring terminal of the output jack to ground the battery negative
turning the instrument on when inserting the Guitar Cable
Battery:
These 2 pins are for the 9 Volt Battery Clip. The battery supplies the pickups and accessories
and only one battery is required.
MASTER
VOLUME
RING
TIP
SLEEVE
B165(rC) Page 4
If the instrument has a Battery Holder:
If your instrument has a 9 or 18-Volt battery holder you can still
use the EMG Connectors to supply power to the pickups.
Simply cut and strip the wires from the battery clip provided.
Twist the wires together and use the shrink tubing included
to cover the connections. Soldering the wires is preferred.
Cover these connections with the
shrink tubing provided.
To PC Board
9/18 VOLT
BATTERY
HOLDER
Diagram #9
- 9V +
Diagram #11