Technical information

C6.1.7/0609-1110/E 17
4.4 Checks before starting up and during operation
 Please check that all Rotalock valves are fully opened.
 Check that the electrical panel is closed.
 After starting up and operation conditions are stabilised, we recommend to check the oil
level in compressor(s) and if needed to add oil to ensure a sufficient oil level (halfway up
the sight glass).
5 Maintenance & repair
 De-energize the unit before any intervention.
 Close Rotalock valves to isolate the compressor from the system and unscrew the flare
Rotalock connector from the compressor.
 Release the compressor mounting parts and then lift it to replace with a new compressor.
For more detailed instructions, please refer to the compressor application guideline.
6 Certification & approval
 The piping is in compliance with the Pressure Equipment Directive 97/23/EEC (Art.3 §3 -
Sound Engineering Practice).
 Components of the units carry a CE mark as far as required and thereby establish
conformity with the relevant directives.
 Conformity Declarations for components are available as far as required.
 The units are in conformity with the low voltage directive. The applied harmonised standard
is EN 60335-1 (Safety Household and Similar Electrical Appliance, Part 1: General
Requirements).
 To incorporate these products into a machine the Manufacturer's Declaration of
Incorporation has to be respected.
7 Dismantling & disposal
Removing oil and refrigerant:
Do not disperse in the environment.
Use the correct equipment and method of removal.
Dispose of oil and refrigerant properly.
Dispose of unit properly.
Safety
instructions
Product
description
Installation
Starting up &
operation
Maintenance &
repair
Certification &
approval
Dismantling &
disposal