Specifications

18 • XR35CX I&O Manual 026-1203 Rev 0 09-FEB-2011
13 How to Use the
Hot Key
13.1.How to Program a Hot
Key From the
Controller (Upload)
1. Program one controller using the front keypad.
2. When the controller is ON, insert the Hot Key and
push the UP arrow key; the uPL message appears
followed by a flashing End LED.
3. Push the SET key and the End LED will stop flash-
ing.
4. Turn OFF the controller, remove the Hot Key, then
turn it ON again.
13.2.How to Program the
Controller Using a Hot
Key (Download)
1. Turn OFF the controller.
2. Insert a programmed Hot Key into the 5-pin recep-
tacle and then turn the Controller ON.
3. Automatically, the parameter list of the Hot Key is
downloaded into the controller memory; the doL
message will blink followed by a flashing End
LED.
4. After 10 seconds, the controller will restart working
with the new parameters.
5. Remove the Hot Key.
NOTE: The Err message is displayed in case of
an error or failure in programming. In this
case push the UP arrow key again if you want
to restart the upload or remove the Hot Key to
abort the operation.
NOTE: The Err message is displayed in case of
an error or failure in programming. In this
case, turn the unit OFF and then ON if you
want to restart the download or remove the Hot
Key to abort the operation.