Instruction manual

1592028000 XWEB300D_500_500D opr GB r2.2.0 2013.08.01.docx XWEB500/300 65/114
3.5.3 PARAMETERS
The Parameter function allows management of the parameters of a selected device. The parameters can be
displayed and modified. From the Home Page, select the “Parameters” item from the “Devices” menu. From
the “Actions” select one of the following functions:
Load from Device:

to load and display the parameters from a device;
Load from File:

to load and display the parameters from the Hard Disk of the Client PC
Write on Device:

to updated the displayed parameters into the selected device;
Write on
Devices:

to updated the displayed parameters into the selected devices
Save on File:

to save the displayed parameters into the Hard Disk of the Client PC.
To show the parameters of a device select “load from device“ from the “action” menu:
Use the filter mask to limits the range of the device selection:
DEVICE
TYPOLOGY:

To filter among the different typologies (“All” includes all the instrument);
Select a Device:

To select the desired instrument;
Select a Group:

To defines only a limited group of parameters to load;
Select “Menu”:

To defines which is the parameter level to use (Pr1, Pr2, All).
After filling the filter mask, click on “Read” button to load the parameter from the instrument to the client pc.
The loading time depends on the number of parameter selected.
The parameter table is defined by these columns:
Label:
The parameter label as described into the instruction manual of the instrument itself;
Description:
Description of the parameter function;