Instruction manual

1592028000 XWEB300D_500_500D opr GB r2.2.0 2013.08.01.docx XWEB500/300 37/114
SHORTCUTS
This sections shows a list of shortcut icons to quicly access to most used XWEB functionalities.
3.3 CONTROLLERS SETUP
In this section you can read instructions on how to configure your XWEB with Devices connected to its
RS485 network.
3.3.1 DEVICE FIND OF THE INSTRUMENTS CONNECTED TO THE “RS485” SERIAL
LINE
The unit is capable to find the Dixell instruments connected to the RS485 serial line. Before starting the
procedure be sure that all the devices are properly connected to the RS485 line and the corresponding
addresses are properly set. Be sure that all the instruments are properly supplied. Be sure of the number of
the instruments you are going to find to avoid losing time in counting them later. To start the procedure, first
click on “Data recording” and uncheck all values, push modify. Click on “Configuration -> “Device find” roll-
down menu. A new page loads.