Troubleshooting guide

Important Note

Before applying power to the VISSION MicroController panel, all wiring to the panel should be per NEC.

Specifically check for proper voltage and that the neutral is grounded at the source. An equipment ground

should also be run to the panel.

*See Wiring Instructions and Diagrams before proceeding.

Before start-up you need to enter all system values and options, see section on Setpoint Values.

“Before powering the Vission control panel down”, it is a good idea to Backup Control Settings to insure

that all previously changed setpoints have been properly saved. See section on saving changes. After back-

ing up the setpoints DO NOT power down the Vission panel for at least 1 minute. This will allow adequate

time for all setpoints to be properly saved.

Note: The screen shots depicted in this manual represent the screens corresponding to

Vission program version # 2.4.41, the current version at time of printing. In our effort

to continuously improve the functionality and ease-of-use of the Vission Micro-con-

troller, the look of some screens may differ slightly than the representations shown

here.

Equipment Indentification Numbers:

Vilter Order Number: __________________________Serial Number: _____________