Service manual

10 – 6
Vission 20/20 • Operation and Service Manual •Vilter/Emerson • 35391SC 2.0
Section 10 • Compressor Sequencing
At this point the slave compressor will begin multicast-
ing its status information over the network at a rate of
every 15 seconds. (After the Master Compressor is con-
fi gured, the slave information will be populated to the
Sequencing menu of the Master Compressor.)
11. Exit out of the confi guration screen and then
put slave in remote mode by pressing Unit
Start->Remote.
Figure 10-5. Placing Slave Compressors in Remote Mode