Service manual

19 – 1
Vission 20/20 • Operation and Service Manual •Vilter/Emerson • 35391SC 1.9
Section 19 • Configuration
Overview
The confi guration screen is where most of the Vission
20/20 features are enabled and confi gured. The initial
setup of the Vission 20/20 will generally start here, see
Figure 19-1. Confi guration Screen - Initial Setup (Page
1). Depending on what is selected, different portions of
the Vission 20/20 will be available to the operator.
Units
This section sets how values will be represented through
out the program.
Temp Units:
• Drop-down box to select the temperature units from
Fahrenheit and Celsius. Once selected, all screen
temperatures will be displayed in the chosen units.
Press Units:
• Drop-down Box to select the pressure units. Psig, Bar,
and Kpa are the possible selections and the units will
be displayed for every pressure value throughout the
screens.
Order Num:
• Identifi es the Order number of the purchase of the
compressor. This Number will be needed If the opera-
tor requires help from Vilter.
Run Hours:
• Offers the ability to change the compressor run
hours. This is typically used when replacing an older
micro controller on and existing compressor with a
new Vission 20/20.
Figure 19-1. Confi guration Screen - Initial Setup (Page 1)