User`s manual
Table Of Contents
- Home
- Contents
- Introduction
- USB Fieldbus Interface
- Software installation and device setup
- Fieldbus Interface Configuration utility
- Using with AMS Device Manager
- Using with an FDT Frame Application
- Troubleshooting
- Approvals and certifications
- Specifications
- Waste disposal
- Install drivers manually
- Disable driver signature enforcement in Windows 8.0 and 8.1
- Remove pre-release driver versions on a Windows XP operating system
- Index
Update device catalogFigure 6-1:
3. Click Yes when prompted to create a new PACTware device catalog.
4. Close the device catalog when done.
6.3 Configure fieldbus devices in an FDT Frame Application
Notes
• Install the Communication DTM software and the DTM Library first before configuring fieldbus
devices in an FDT Frame Application. For more information, see Section 3.3 and Section 3.4.
• If necessary, update the DTM library. For more information, see Section 6.2.
• Make sure the USB Fieldbus Interface and fieldbus devices are correctly set up and that the
Fieldbus Interface Configuration utility is installed and running. For more information, see
Section 3.5 and Chapter 4.
1. Launch PACTware.
2. From the Project pane, right-click HOST PC and click Add device.
May 2014 User's Manual
33