Satellite Radio User Manual

If using shielded or armored cable:

a. Ground the shield drain wires (the black wire) only on the core

processor end, by connecting it to the ground screw inside the

lower conduit ring. Do not ground to the core processor’s

mounting screw. Do not ground the cable at the sensor junction

box.

b. Ground the cable braid on both ends, by terminating it inside the

cable glands.

4. Ensure integrity of gaskets, grease all O-rings, then close the junction

box housing and core processor end-cap, and tighten all screws.

STEP 8. Connecting power supply wiring

CAUTION

Damaging the wires that connect the transmitter to

the sensor can cause measurement error or meter

failure.

To reduce the risk of measurement error or meter failure,

when closing the housings on the sensor and core

processor, make sure that the wires are not caught or

pinched.

CAUTION

Improper wiring installation can cause device failure

or measurement error.

• To avoid device failure or measurement error, do not

install power supply wiring in the same cable tray or

conduit as input/output wiring.

• Shut off power supply before installing the applications

platform.

• Make sure power supply voltage matches voltage that

is indicated on power supply wiring terminals. See

Figure 12.