Brochure

HOW DO YOU PROTECT YOUR POWER?
Employing an entire facility protection strategy will safeguard the electrical system against most transients. Multi-stage
protection involves clamping the initial high-energy surge, filtering any remaining noise or transients to the protected
sensitive equipment and finally, protecting the data/signal lines entering or leaving the control panel or the factory floor.
This coordination of devices provides the lowest possible let through voltage to the equipment.
Surge Suppressor
STV100k Series
LINE
1
LINE
2
SERVICE
Surge Suppressor
STV100k Series
LINE
1
LINE
2
SERVICE
Surge Suppressor
STV100k Series
LI NE
1
LI NE
2
SE RVIC E
STV 100K
Surge Suppressor
Device (SPD)
K-Factor
Harmonic
Transformer
STV 100K
Surge Protective
Device (SPD)
SDU Off-Line UPS
LVGP
Transformer
S5K Modular UPS
MCR Series
Constant Voltage
Power Conditioner
Distribution
Transformer
Solatron Plus
Three Phase
Power Conditioner
L
N
G
L1
L2
G
LOAD
LINE
L
N
G
L1
L2
G
Active Tracking Filter
STFV Plus Series
Status OK
STFV Plus Series
Surge Protection and
Active Tracking Filter
STC-CCTV-751
E
Q
U
I
P
C
A
B
L
E
STC-CCTV
Surge Protective
Device For Coaxial
Active Tracking Filter
STF Elite Series
OK
Active Tracking Filter
STF Elite Series
OK
LINE
LINE
SHIELD
STS-DRS -06 0
1
2
3
4
5
6
LINE
LINE
SHIELD
STS - D R S - 060
1
2
3
4
5
6
STC-DRS
DIN mounted
Surge Protective
Device For Data
Signals
STF Elite
Active Tracking
Filter With
Surge Protection
STC-PoE
Ethernet Surge
Protective Device
(located behind server)
Surge Prote ctive Device
STV200/400K Series
REDUCED
PROTECTION
FULL
PROTECTION
MODULE
1
MODULE
2
ALARM
DISABLED
TEST
STV 200/400K
Service Entrance
Surge Protective Device
B
C
D
E
F
G
A
STV200/400K: Surge protective devices capable of handling the
high-impulse, potentially damaging transients commonly found
at the service entrance, distribution panels, and placement in the
most severe exposure locations.
STV100K: Surge protective devices designed to protect sensitive
equipment and microprocessor-based systems from transients on
distribution and sub-distribution panels, or any medium exposure
locations.
B
STC-POE: Surge protective devices designed to work on
Power-over-Ethernet Category 5 PoE transmission lines as well as
Category 6 applications.
C
STC-DRS: DIN Rail mountable, single pair, low voltage data,
surge protective devices. e hybrid design of these data/signal line
suppressors allows them to respond quickly.
D
STFE Elite: DIN Rail Mountable high-frequency noise lter/
surge suppressors that oers the original active tracking technol-
ogy with UL approved transient protection to guard against
commonly occurring, but very damaging transients, plus provides
excellent noise reduction.
E
STC-CCTV: Surge protective devices tailored to protect
CCTV, data, audio and cable applications.
F
STFV: High-frequency noise lter/surge suppressors that oers
the original active tracking technology with transient protection
to guard against commonly high voltage transients, plus provides
excellent noise reduction.
G
A