Instruction manual

41
MODEL XMT-A-FF/FI SECTION 7.0
PROGRAMMING THE TRANSMITTER
SECTION 7.0
PROGRAMMING THE TRANSMITTER
7.1 GENERAL
This section describes how to program the transmitter using the keypad.
1. Select the measurement to be made (oxygen, ozone, free chlorine, total chlorine, or monochloramine).
2. Choose temperature units and automatic or manual temperature mode.
3. Set a security code.
4. Program the transmitter for maximum reduction of environmental noise.
Default settings are shown in Table 7-1. To change a default setting, refer to the section listed in the table. To return the
transmitter to the default settings, see Section 7.9.
7.2 CHANGING START-UP SETTINGS
When the Solu Comp Xmt is powered up for the first time, startup screens appear. The screens prompt the user to
enter the measurement being made and if oxygen was selected, to identify the sensor being used, to select automat-
ic or manual pH correction (free chlorine only) and to select temperature units. If incorrect settings were entered at
startup, enter the correct settings now. To change the measurement, refer to Section 7.3.