Instruction manual
5. Choose the desired language. Choose >> to show more choices.
6. Choose type of measurement: Oxygen, Ozone, Free Chlorine, Total Chlorine, or
Monochloramine. To see more choices, move the cursor to >> and press ENTER.
If you chose Oxygen, go to step 6a.
If you chose Ozone, go to step 7a.
If you chose Free Chlorine, go to step 8a.
If you chose Total Chlorine or Monochloramine, go to step 9a.
7a. For Oxygen, select the manufacturer of the sensor, Rosemount or Other. If you chose
Rosemount, go to step 6b. If you chose Other go to step 6c.
7b. Select the application: Water/Waste, Trace Oxygen, or Biopharm. To see more choic-
es, move the cursor to >> and press ENTER.
7c. Choose the units in which you want the oxygen measurement displayed. If you chose
partialPress (partial pressure), the default units are mm Hg. To select different units,
refer to Section 7.3.3.
7d. Choose temperature units: °C or °F.
8a. For Ozone, select units: ppm or ppb.
8b. Choose temperature units: °C or °F.
9a. For Free Chlorine, select Auto or Manual pH compensation.
9b. If you selected Manual, enter the pH of the process liquid.
9c. Choose temperature units: °C or °F.
10a.For Total Chlorine and Monochloramine, choose temperature units: °C or °F.
11. To change output settings, to scale the 4-20 mA output, to change pH-related settings
(free chlorine only) from the default values, and to set security codes, press MENU.
Select Program and follow the prompts. For more information refer to section 7.0. For
calibration information, refer to section 8.0.
12. To return the transmitter to default settings, choose ResetAnalyzer in the Program menu.
The menu tree for the Solu Comp Xmt-A-FF/FI is on the following page.
Measurement type
Oxygen
Ozone >>
units?
ppm
%sat ppb >>
units?
ppm
ppb
Application?
Water/Waste
>>
Manufacturer?
Rosemount
Other
Temperature in?
°C °
F
Temperature in?
°C °
F
pH Comp?
Auto
Manual
Manual pH
0
7.00 pH
Temperature in?
°C °
F
Temperature in?
°C °
F
1. Refer to Section 2.0 for installation instructions.
2. Wire sensors to the analyzer. See section 3.0.
3. Once connections are secure and verified, apply power to the transmitter.
4. When the transmitter is powered up for the first time, Quick Start screens appear. Using Quick Start is easy.
a. A blinking field shows the position of the cursor.
b. Use the
or key to move the cursor left or right. Use the or key to move the cursor up or down or to increase or
decrease the value of a digit. Use the
or key to move the decimal point.
c. Press ENTER to store a setting. Press EXIT to leave without storing changes. Pressing EXIT also returns the display to the
previous screen.
QUICK START GUIDE
FOR MODEL SOLU COMP Xmt-A-FF/FI TRANSMITTER
English
Franais
Espaol >>