Instruction manual

5
MODEL XMT-A-FF/FI SECTION 1.0
DESCRIPTION AND SPECIFICATIONS
1.3 TRANSMITTER DISPLAY DURING CALIBRATION AND PROGRAMMING
The display can be readily configured to meet user requirements.
Basic display for all measurements:
For the measurement of oxygen, a variety of units are available: ppm, ppb (for 499ATrDO sensor only), % saturation,
and partial pressure (in units of mm Hg, in Hg, bar, mbar, atm, or kPa).
For chlorine measurements with continuous pH correction, the basic display also shows the pH.
A display showing the raw sensor current can also be selected.
1.4 FOUNDATION FIELDBUS COMMUNICATION
The Model 375 HART and FOUNDATION Fieldbus Communicator is a hand-held device that provides a common link to all
HART SMART and FOUNDATION Fieldbus instruments and allows access to AMS (Asset Management Solutions). Use
the 375 communicator to set up and control the Xmt-A-FF and to read measured variables. Press ON to display the on-
line menu. All set-up menus are available through this menu.
1.234ppm
25.0°C 12.34mA
1.234ppm
7.89pH 25.0°C
1.234ppm
25.0°C 500nA
FIGURE 1-1. CONFIGURING MODEL Xmt-A TRANSMITTER WITH FOUNDATION FIELDBUS