Instruction manual

MODEL XMT-C SECTION 6.0
OPERATION WITH MODEL 375
Detailed setup
Sensors
Main sensor
PV Type [Conductivity, Resistivity, 0-12% NaOH, 0-15% HCl, 0-25% H2SO4, 96-99.7% H2SO4,
0-20% NaCl, TDS, Custom]
PV Snsr unit [uS/cm, uS/m, mS/cm, mS/m, Mohm-cm, %, ppm, _]
Cond unit [uS/cm, uS/m, mS/cm, mS/m] ****
Define curve ****
View custom points ****
Cell constant
Temp comp type [Linear, Neutral salt, Cation, None/Off] *..
Temp slope ***
Ref temp *** AND *. , ****
PV sensor type
Sensor information
LSL
USL
Min span
Temperature
ATC [On, Off]
Man temp
Temp unit [ºC, ºF]
Temp snsr [RTD PT100, RTD PT1000, Manual]
Diag override
PV>display limit [ON, OFF]
EE write Error [ON, OFF]
EE chksum Error [ON, OFF]
EE buf overflow [ON, OFF]
% out of range [ON, OFF]
Need zero cal [ON, OFF]
Temperature high [ON, OFF]
Temperature low [ON, OFF]
Sense line open [ON, OFF]
Need factory cal [ON, OFF]
Input Overrange [ON, OFF]
A2D Read Error [ON, OFF]
RTDohm overrange [ON, OFF]
RTD open [ON, OFF]
Signal condition
LRV
URV
AO Damp
% rnge
Xfer fnctn
AO1 lo end point
AO1 hi end pt
Output condition
Analog output
AO1
AO Alrm typ
Fixed
Fault mode [Fixed, Live]
Fault
Loop test
D/A trim
FIGURE 6-2. XMT-C-HT HART/Model 375 Menu Tree (2 of 3)
45