Instruction manual

MODEL 5081-C SECTION 9.0
OPERATION w ITH MODEL 375
Transducer Error
ST_REV
BLo CK_ERR
Additional transmitter status
Fault history 0
Fault history 1
Fault history 2
Block Mode
Mo d E_BLK: Actual
Mo d E_BLK: Target
Mo d E_BLK: Permitted
STRATEGY
ALERT_KEY
Characteristics Block Tag
TAG_d ESC
Measurements
Prim Val Type
Primary Val: Primary Val
Primary Val: Status
Primary Value Range: Eu at 100%
Primary Value Range: Eu at 0%
Secondary variable: Value
Secondary variable: Status
Raw RTd o hms
Raw PV: Raw PV
Raw PV: Status
Conductance
Calibration
PV Cal
Sensor Zero
SV Cal
Calibrate Meter
Configuration
Change PV Type
Sensor type conductivity
Prim Val Type
Conductivity unit
d iagnostic override
Calibration Parameters
Cell constant
Conductance offset
Solution/Conductivity offset
input cal factor
Temperature calibration offset
Snsr Cal Meth
Snsr Cal d ate
Temperature Compensation
Secondary value units
Sensor temperature compensation
Sensor temp manual value
Temp comp type
Temperature slope
Raw RTd ohms
Sensor type temp
Custom Curve
Reset transducer/Load factory defaults
identification
Software revision level
Hardware revision level
Lo i security code
Sensor S/N
Final assembly number
Ai blocks simulation
Ai1
Ai2
Ai3
Quick Config
Ai Channel
L_TYPE
Xd _SCALE: Eu at 100%
Xd _SCALE: Eu at 0%
Xd _SCALE: u nits index
Xd _SCALE: d ecimal
o u T_SCALE: Eu at 100%
o u T_SCALE: Eu at 0%
o u T_SCALE: u nits index
o u T_SCALE: d ecimal
Common Config
ACK_o PTio N
ALARM_HYS
FIGURE 9-3. 5081-C-FF Model 375 Menu Tree (2 of 10)
59