Instruction manual

MODEL 5081-C SECTION 7.0

PROGRAMMING

SECTION 7.0

PROGRAMING

7.1 General

7.2 Output

7.3 Temp

7.4 Display

7.5 HART

7.6 Setup Cust

7.7 Default

7.1 GENERAL

This section describes how to do the following:

1. assign values to the 4 and 20 mA outputs (for 5081-C-HT only)

2. set the current generated by the transmitter during hold (for 5081-C-HT only)

3. set the current generated by the transmitter when a fault is detected (for 5081-C-HT only)

4. change sensor diagnostic limits

5. enable and disable automatic temperature correction

6. program the type measurement

7. choose limits for diagnostic fault messages

Model 5081-C-HT Model 5081-C-FF

Output temp

temp Display

Display Setup Cust

HART Default

Setup Cust

Default